Bdbkifnff

Smilence03

As bxbdjdjjdbbf

Balabalabala~ 一大堆话。总之，如果有时间的话可以尝试一下那个bridging program。我之前还想去报名Physics在今年十一月份的senior external exam，但错过了报名时间╮(╯▽╰)╭。。。
最后我还是决定到QUT去上。第一年的Engineering是common year，所以可以上了一年再决定到底是留在QUT还是转到UQ。但转到UQ可能得不到full credit，也就是要再花一些时间上UQ第一年中没有在QUT cover到的courses。
希望这些信息可以帮助到你。

哇！我们遇到了一模一样的问题吖！只不过我感兴趣的是机械与航空工程。建议还是直接问学校。以下是UQ通过邮件对我的答复。

“Thank you for your email and your interest in studying the Bachelor of Engineering (Mechanical and Aerospace Engineering) at the University of Queensland.

You will have to apply through QTAC (www.qtac.edu.au) for a place at UQ and meet the Entry Requirements for the Bachelor of Engineering.  The 2011 Entry Requirements are on our Courses and Programs website - http://www.uq.edu.au/study/program.html?acad_prog=2001, but these can change from year to year.     As you can see, you will need at least Maths B (preferably Maths C) and either Physics or Chemistry (preferably both) and an OP/Rank of 6/90 or better to satisfy the present entry requirements.   If you won't have the required courses you can enrol in Bridging courses to be eligible for Engineering.   Some Bridging programs are designed to meet the requirements of a specific institution and therefore are not accepted at another institution.  The following link will provide you with a list of bridging programs accepted by the University of Queensland:  www.uq.edu.au/study/docs/domestic/bridging.pdf.

Or

When you apply to QTAC, you could list your second preference as the Bachelor of Information Technology (http://www.uq.edu.au/study/program.html?acad_prog=2230) where the Entry Requirements and OP/Rank are not so high.   Have a look at the Course List - it says that you may enrol in no more than #16 from courses not in the BInfTech list.  

If you do not get a Sound Achievement in Maths B you could look at enrolling in the Bachelor of Multimedia Design (http://www.uq.edu.au/study/program.html?acad_prog=2221) as your third preference.   Their Program Rules and Requirements state “#16 from Part B, or from Parts A or B of the BInfTech list or from other courses approved by the Executive Dean”.

This means you could enrol in some of the 1st Year Engineering courses as well as MATH1040 (equal to Maths B), or MATH1050 (equal to Maths C), PHYS1171 (equal to Year 12 Physics) and/or CHEM1090 (equal to Year 12 Chemistry),  but you would not get credit for all of them as Physics or Chemistry and Maths B are prerequisites for entry in to the BE.         Once you have the pre-requisite courses, you can apply to change to the Bachelor of Engineering degree.                     

There is more information on our Engineering Plans in our 2012 Prospectus - http://issuu.com/uqeaitfaculty/d ... p;showFlipBtn=true.

I hope this information is useful, but if you have more questions please don't hesitate to email again.

Good luck with your studies

Regards
Valerie

Valerie Hutchinson
Student Enquiries Officer
Faculty of Engineering, Architecture and Information Technology (EAIT)
University of Queensland
Brisbane
Queensland 4072”

好，楼主很有前途：）

补充一句，去之前最好先发个邮件预约时间。具体信息UQ网站上查相关院系办公室的资料吧。

回复 3# Smilence03


    抽空来趟学校，直接去相关的院系办公室或者UQ学生中心咨询。

回复 2# badyzy


    你好，我目前还是12年级在校生马上毕业……

回复 1# Smilence03


   您得提供非常强悍的证据, 比方说工作经验，来证明您不需要上这种课程。我觉得还是有希望的。